Full output at quiet hours
Lights running at full output during periods of low activity in car parks and corridors.
LumiPLUS
Smart lighting for car parks, corridors and common areas.
LumiPLUS uses sensing, group control and configurable dimming to reduce unnecessary lighting operation while maintaining the lighting experience required by your site.
Customer challenges
Where lighting cost and effort build up
Uneven motion response
Sensors acting individually, leaving dark patches ahead of people and vehicles.
Manual inspections
Faults found by walking the site rather than from device status information.
Features
Lighting that responds to the way the space is used
- Motion-based dimming per zone
- Coordinated group sensing across neighbouring fixtures
- Lighting ahead of movement along a route
- Scheduling for known operating patterns
- Configurable standby levels rather than full off
- Zone-by-zone settings for different areas
Hardware selection
Fixtures chosen after the site assessment
Smart T8 tubes and other suitable fixtures
Smart T8 tubes and other suitable fixtures are available. Selection follows the site assessment, covering existing fittings, mounting, wiring and the lighting levels each area requires.
Retrofit-friendly, subject to site verification
Many existing installations can be upgraded with limited works, but suitability is confirmed on site. We do not assume that every existing fixture can be reused without changes.
Operation
Local control, with optional online management
Local lighting control
Local lighting control can operate through the selected Bluetooth Mesh configuration, so sensing, dimming and schedules continue to run within the site.
Optional online management
Remote dashboards, reporting and integrations depend on the specified gateway, connectivity and platform services, and are quoted as part of the project scope.
Management functions
Floor-plan visibility, device status and maintenance functions are available where included in the selected package.
Optional gateway, cloud, metering and integration features depend on scope. Not every software feature is standard in every deployment.
Verify the result
Measure before and after, in the same area
- 1
Baseline with IntelliPLUS
Monitoring records the existing lighting load and operating patterns before any change.
- 2
Upgrade the pilot area
LumiPLUS is installed, configured and commissioned in the same defined area.
- 3
Compare and decide
Measured before and after consumption is reviewed against the agreed forecast before a wider rollout.
Lighting POC process
A defined pilot helps your committee compare expected savings with measured performance before deciding on a building-wide rollout.
FAQs
Practical questions before a lighting project
Is LumiPLUS suitable for retrofit?
LumiPLUS is retrofit-friendly, subject to site verification. Existing fixtures, wiring and mounting conditions are reviewed during the site assessment before any fixture selection is confirmed.
Does lighting control need an internet connection?
Local lighting control can operate through the selected Bluetooth Mesh configuration. Remote dashboards, reporting and integrations depend on the specified gateway, connectivity and platform services.
Can brightness levels be adjusted?
Yes. Motion response, dimming levels, standby levels and schedules are configured per zone to maintain the lighting experience your site requires.
How is the result measured?
IntelliPLUS baseline monitoring records the existing lighting load, and monitoring continues after the upgrade so before and after consumption can be compared. Savings require site measurement.
What defines the project scope?
Scope follows the site assessment: areas covered, fixture count and type, sensing strategy, and whether gateway, cloud and integration features are included.
Request a Lighting Assessment.
Tell us about the areas you want to improve, your operating hours and the current lighting setup. We will identify the information needed to define a suitable scope.